Dillon Quick-Check Wire Tension Meter (Red) Manual do Utilizador descarregar pdf (Página 26)

26 Quick-Check Red User Instructions

4 Configuration Mode

4.1 Accessing the Configuration Mode

You need to access the Configuration mode to perform certain tasks. Access to some

of these tasks may be restricted by a supervisor password.

To access Configuration mode:

1. From normal operating mode, press the Right Arrow softkey…

A new softkey set, shown below, appears:

2. Press the Config softkey…

The following is displayed:

3. Use the Num and Adv keys to enter the Config password. Default is 0. After

the number is displayed, press the Enter key…

The following is displayed:

Units Log

Setup Config

lbf

7/16 6X19

Shv:S

The Num keys increment and decrement the displayed numbers. The Adv key

moves the cursor to the next digit position.

Default Configuration password is 0. If a new password is lost or forgotten, contact

your Dillon distributor.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 37 38

Sem comentários

Dillon Quick-Check Wire Tension Meter (Red) Manual do Utilizador Página 26