Dillon Quick Balance Tension Meter Manual do Utilizador

Quick BalanceTension MeterUser InstructionsAWT 35-500545 Issue AA April 2010

10 Quick Balance User Instructions2.3 Important featuresQuick to use Attaches and removes from tensioned line in seconds. Quick readout for ultra fas

Quick Balance User Instructions 113 OperationTypical operation of the Quick Balance is covered below, followed by explanations of the various display

12 Quick Balance User Instructions4. Release the lever arm and you are ready to perform another measurement.Figure 3.2 Quick Balance attached to cab

Quick Balance User Instructions 13Insure sheaves installed agree with sheaves noted in the Wire calibration. Exception: Sheaves match the wire diamete

14 Quick Balance User InstructionsTemperature Mode: This mode shows the live tension in the top display and the current temperature in the bottom dis

Quick Balance User Instructions 15Units Press this key to set the Quick Balance for displaying:l Force in lbf, kgf or Nl Size of wire in inches or mil

16 Quick Balance User InstructionsAbout Press this softkey to see the following information:Device - Press this softkey to show a list of informatio

Quick Balance User Instructions 17Config This is a password protected menu. See Configuration Mode on page 18.Press the ESC key to return to the norma

18 Quick Balance User Instructions4 Configuration Mode4.1 Accessing the Configuration ModeYou need to access the Configuration mode to perform certai

Quick Balance User Instructions 194. The unit is now in the Configuration mode. To see the rest of the softkeys available in this mode, press the Righ

© Avery Weigh-Tronix, LLC 2010. All rights reserved. No part of this publication may be reproduced, stored in an electronic retrieval system, or trans

20 Quick Balance User InstructionsUnits Press this softkey to set the following:l Unit of measure on power up. Choices are Last*, C2, C1, N, kgf, and

Quick Balance User Instructions 215 Changing SheavesAs you use the Quick Balance on different diameter cables you must change to the correct sheave si

22 Quick Balance User Instructions6 Achieving Best Accuracy6.1 AccuracyThe Quick Balance is an instrument designed to give accuracy that typically ex

Quick Balance User Instructions 236.3 Loading ErrorA tensiometer works by deflecting the cable, which makes the cable path longer than when a tensiome

24 Quick Balance User Instructions7 TroubleshootingProblem Possible Cause SolutionPowers on momentarily and turns off Low battery Replace with high q

Overload Protection and Overhead Weighing EquipmentFairmont, Minnesota U.S.A.Toll-Free: (800) 368-2031Phone: (507) 238-4461Fax: (507) 238-8258www.dill

Quick Balance User Instructions 3Table of ContentspageChapter 1 General information and warnings ...

4 Quick Balance User Instructions

Quick Balance User Instructions 51 General information and warnings1.1 About this manualThis manual is divided into chapters by the chapter number and

6 Quick Balance User Instructions1.2 Installation1.2.1 Safe handling of equipment with batteries1.3 Routine maintenanceAlways turn off the machine an

Quick Balance User Instructions 71.4 Cleaning the machine1.5 TrainingDo not attempt to operate or complete any procedure on a machine unless you have

8 Quick Balance User Instructions2 IntroductionThis manual covers the setup and operation of the Quick Balance Tension Meter from Dillon. The Quick B

Quick Balance User Instructions 9The front panel of the Quick Balance is shown in Figure 2.2.Figure 2.2 Quick Balance front panelFollowing are descri